QHY294M Pro The QHY294M Pro is a cooled monochrome astronomy camera using SONY IMX492. This monochrome IMX492 camera provides two distinct sampling modes: standard 11.7 MP at 4.63 µm and 14-bit ADC, or unlocked approximately 46.8 MP at 2.315 µm and 12-bit ADC. Changing mode also changes full well, read noise and frame rate; values from the two modes must…
Manufacturer model: QHY294M Pro · Specifications checked against manufacturer data on 2026-11-03
The QHY294M Pro is a cooled monochrome astronomy camera using SONY IMX492. This monochrome IMX492 camera provides two distinct sampling modes: standard 11.7 MP at 4.63 µm and 14-bit ADC, or unlocked approximately 46.8 MP at 2.315 µm and 12-bit ADC. Changing mode also changes full well, read noise and frame rate; values from the two modes must be compared separately.
Sensor readout and image transfer
QHY’s published ADC specification is 14-bit A/D. A 256MB DDR3 Memory Buffer image buffer supports downloads through USB3.0. Monochrome capture supports separate luminance, RGB and narrowband filter exposures. Full-frame and region-of-interest rates depend on readout mode and output format; the table below preserves those conditions.
Cooling and dew control
Manufacturer cooling specification: Dual Stage TEC cooler（about -35℃ below ambient, test temperature +20℃）. Cooling reduces thermal signal during long exposures, and performance depends on ambient conditions and capture rate. The camera has the manufacturer-listed dew-control provisions shown in the table.
Optical connections
The listed interface is M42/0.75, with backfocus of 17.5mm（±0.2）. Add the optical contribution of the selected adapters, filter wheel and guider when planning the telescope connection.
Power and software
Use an external 12 V supply before connecting the USB data cable. QHY’s operating guide specifies 11–13.8 V at the camera; cable voltage drop must be included in the power budget. Use the manufacturer-specified power adapter. Install the matching QHY All-in-One driver/SDK and compatible capture software.
Use the named-model manufacturer connection diagram and the backfocus reference for the selected adapter. Readout mode and output format affect frame rate, noise and full-well capacity.
Additional specifications
Standard sampling mode
11.7 MP; 4164 × 2796 pixels; 4.63 µm; 14-bit ADC
Unlocked sampling mode
46.8 MP nominal; 2.315 µm; 12-bit ADC according to manufacturer mode overview
Unlocked frame rate note
The manufacturer table separately prints 8340 × 5644 at 4 fps; the mode overview specifies 12-bit ADC for unlocked mode. These are retained as distinct published statements, not a 14-bit unlocked-mode guarantee.
85058
Scheda tecnica
ADC e uscita
14-bit A/D
Bagliore dell'amplificatore
Amplifier Glow Can be reduced during long exposure
Riscaldatore anticondensa
Available
Back focus
17.5mm（±0.2）
Modalità colore
Monochrome
Interfaccia computer
USB3.0
Software di controllo
QHY All-in-One drivers/SDK; compatible ASCOM and capture software such as NINA, SharpCap and EZCAP_QT
Raffreddamento
Dual Stage TEC cooler（about -35℃ below ambient, test temperature +20℃）
Corrente di buio
0.002e-/pixel/sec @-20℃; 0.005e-/pixel/sec @-10℃
Area effettiva dei pixel
4164*2796
Pixel effettivi
11.7 MP; 46.8 MP（Extended Pixel Mode）
Intervallo dei tempi di posa
60μs-3600sec
Frequenze di fotogrammi
Standard 11.7 MP mode: 16.5 fps at 14-bit; smaller ROI increases speed; see manufacturer mode table
Capacità full well 1×1 / 2×2 / 3×3
65ke-
Buffer immagine
256MB DDR3 Memory Buffer
Modello
QHY294M Pro
Collegamento ottico
M42/0.75
Dimensione pixel
4.63μm*4.63μm
Ingresso di alimentazione
12 V DC external supply; manufacturer guide specifies 11–13.8 V at the camera
Sequenza di alimentazione
Connect 12 V power before USB; use a short, low-resistance power cable
Finestra di protezione
AR+AR High Quality Multi-Layer Anti-Reflection Coating
Rumore di lettura
1.6- to 1.2e- (High Gain Mode); 6.9- to 5.2e- (Low Gain Mode)
Guadagno consigliato
1600 (11MP Mode); 2600 (47MP Mode)
Sensore
SONY IMX492
Illuminazione del sensore
BSI
Dimensione del sensore
4/3 inch (19.28mm*12.95mm)
Otturatore
Electronic Rolling Shutter
Peso
650g
Hai usato questo prodotto? Condividi la tua esperienza con altri astronomi.
Commenti (0)
Ancora nessuna recensione da parte degli utenti.
Non è stato possibile inviare il tuo giudizio sulla recensione
Segnala commento
Sei sicuro di voler segnalare questo commento?
Segnalazione inviata
La tua segnalazione è stata inviata e sarà esaminata da un moderatore.
Non è stato possibile inviare la tua segnalazione
Scrivi la tua recensione
Recensione inviata
Il tuo commento è stato acquisito e sarà disponibile dopo l'approvazione da parte di un moderatore.
QHY294M Pro The QHY294M Pro is a cooled monochrome astronomy camera using SONY IMX492. This monochrome IMX492 camera provides two distinct sampling modes: standard 11.7 MP at 4.63 µm and 14-bit ADC, or unlocked approximately 46.8 MP at 2.315 µm and 12-bit ADC. Changing mode also changes full well, read noise and frame rate; values from the two modes must…
Manufacturer model: QHY294M Pro · Specifications checked against manufacturer data on 2026-11-03
