Gerd Neumann jr. CTU XL M68x1 Camera Tilting Unit A camera tilt adjuster for large sensors. Three radial screws act on a conical surface, while disc springs retain the camera. Fine external adjustment helps correct sensor alignment and can reduce Newton rings in H-alpha imaging.
Manufacturer model: Gerd Neumann jr. CTU XL M68x1 Camera Tilting Unit · Specifications checked against manufacturer data on 2026-11-04
A camera tilt adjuster for large sensors. Three radial screws act on a conical surface, while disc springs retain the camera. Fine external adjustment helps correct sensor alignment and can reduce Newton rings in H-alpha imaging.
Compatibility and setup
Legacy CTU XL M68×1, supplier 55175. Not the current CTU XT or XL 2.7-inch AP. Adjust from outside without removing the camera. Supplier lists 69 mm free transmission; this is not a guarantee of 69 mm unobstructed aperture through an attached M68 adapter.
Legacy CTU XL M68×1, supplier 55175. Not the current CTU XT or XL 2.7-inch AP. Adjust from outside without removing the camera. Supplier lists 69 mm free transmission; this is not a guarantee of 69 mm unobstructed aperture through an attached M68 adapter.
Additional specifications
Connections
M68×1 on both sides
Adjustment travel
1 mm total
Adjustment rate
0.2 mm separation change per screw revolution
Body diameter
119 mm
Included adapter
Continuous M68×1 male-thread adapter
55175
Datasheet
Optische lengte
17.3 mm
Dit product gebruikt? Deel je ervaring met andere astronomen.
Commentaar (0)
Geen klantenbeoordelingen op het moment.
Uw beoordelingswaardering kan niet worden verzonden
Rapporteer reactie
Bent u zeker dat u deze opmerking wil rapporteren?
Melding verzonden
Uw opmerking is ingediend en zal door een beheerder worden behandeld.
Uw opmerking kan niet worden verzonden
Schrijf uw recensie
Beoordeling verstuurd
Uw beoordeling is toegevoegd en wordt beschikbaar zodra deze is goedgekeurd.
Gerd Neumann jr. CTU XL M68x1 Camera Tilting Unit A camera tilt adjuster for large sensors. Three radial screws act on a conical surface, while disc springs retain the camera. Fine external adjustment helps correct sensor alignment and can reduce Newton rings in H-alpha imaging.
Manufacturer model: Gerd Neumann jr. CTU XL M68x1 Camera Tilting Unit · Specifications checked against manufacturer data on 2026-11-04
