10Micron Baader OMS-Nano Remote Switch The Baader OMS-Nano V2 is a network-operated remote switch for 10Micron mounts with Control Box V1/QCI or V2. It actuates the mount’s external on/off-switch input so an observatory operator can start or shut down the mount remotely.
Manufacturer model: 10Micron Baader OMS-Nano Remote Switch · Specifications checked against manufacturer data on 2026-11-04
The Baader OMS-Nano V2 is a network-operated remote switch for 10Micron mounts with Control Box V1/QCI or V2. It actuates the mount’s external on/off-switch input so an observatory operator can start or shut down the mount remotely.
The module joins the local LAN and is accessed through its assigned IP address using a web browser. It is preconfigured for the supported 10Micron arrangement. USB is used for network configuration or firmware updates; normal operation uses the network cable.
The OMS-Nano sends a momentary signal for a few seconds rather than maintaining a permanent connection. The maker describes the EXT SWITCH jack contacts as parallel to the mount’s front rocker switch. This 2455031 V2 product must not be confused with the separate 2455032 OMS-Nano V3.
The manufacturer lists a 12 V power adapter, 1 m mount connection cable, 3 m LAN cable, 2 m USB cable and instructions. Published net weight is 0.21 kg. It is a remote switch interface, not a multi-outlet power-distribution controller.
Baader Planetarium manufacturer documentation
Exact Baader 2455031 / OMS-Nano V2 identified. Supports V1/QCI and V2, rather than the separate V3 product. The momentary external-switch connection must not be represented as a permanent supply relay.
| Model version | OMS-Nano V2 |
|---|---|
| Compatible control boxes | 10Micron V1 (QCI) and V2; not the V3 version |
| Network interface | LAN/Ethernet; browser access by assigned IP |
| USB function | Network configuration and firmware updates |
| Switching behaviour | Momentary signal for a few seconds; not a permanent closed connection |
| Mount connection | Three-contact EXT SWITCH stereo jack; two front contacts in parallel with the rocker switch, without ground |
| Supply | Included 12 V power adapter |
| Mount connection cable length (m) | 1 |
| Lan cable length (m) | 3 |
| USB cable length (m) | 2 |
| Included equipment | OMS-Nano unit; power adapter; connection cable; LAN cable; USB cable; instructions |
Data sheet
Specific References
10Micron Baader OMS-Nano Remote Switch The Baader OMS-Nano V2 is a network-operated remote switch for 10Micron mounts with Control Box V1/QCI or V2. It actuates the mount’s external on/off-switch input so an observatory operator can start or shut down the mount remotely.
Manufacturer model: 10Micron Baader OMS-Nano Remote Switch · Specifications checked against manufacturer data on 2026-11-04
